LTPL-C34UVE365 价格优势

Notes:
1. The LEDs can be soldered using the reflow soldering or hand soldering method. The recommended hand
soldering condition is 300°C max and 2secs max, only once, and the operation of reflow soldering is only up to
three times at maximum.
2. All temperatures refer to topside of the package, measured on the package body surface.
3. The soldering profile could be further referred to different soldering grease material characteristic. The grease
vendor will provide this information.
4. A rapid-rate process is not recommended for the LEDs cooling down from the peak temperature.
5. Although the recommended reflow conditions are specified above, the reflow or hand soldering condition at the
lowest possible temperature is desirable for the LEDs.
6. LiteOn cannot make a guarantee on the LEDs which have been already assembled using the dip soldering
method.
7. Recommend printed circuit board attachment pad specification tolerance ±0.1mm.

UVC：
短波UVC，波长介于200～300纳米，又称为短波灭菌紫外线。它的穿透能力弱，无法穿透大部分的透明玻璃及塑料。日光中含有的短波紫外线几乎被臭氧层完全吸收，在到达地面之前就被臭氧层吸收了。
对人体伤害程度：大自然中的UVC由于未到达地面就被臭氧层吸收了，对皮肤的影响可以忽略，但其实短波紫外线对人体的伤害是很大的，不可以直接照射人体。若直接照射，短时间照射即可灼伤皮肤，长期或高强度照射还会造成皮肤。
应用领域：紫外线杀菌灯发出的就是UVC短波紫外线。短波紫外线被广泛应用于医院，空调系统，消毒柜，水处理设备，饮水机，污水处理厂，游泳池，食品饮料加工及包装设备，食品厂，化妆品厂，奶制品厂，酿酒厂，饮料厂，面包房和冷藏室等领域。

Notes:
1. Radiant flux (Φe) is the total Radiant flux output as measured with an integrating sphere.
2. Forward voltage (Vf) measurement tolerance is ± 0.1V
3. Peak Wavelength measurement tolerance is ± 3nm
4. Forward Radiant Flux measurement tolerance is ± 10%
5. The thermal resistance is defined as the figure. Rth j-s is the thermal resistance from chip junction to solder.
Reference for thermal resistance: Using 2.0x2.0x0.17cm aluminum MCPCB

1.采用进口铝反射镜使紫外线照射优。
2.紫外线灯管有4w、6w、8w等多种功率可供选择。
3.长波紫外线灯管可选择自滤色紫外线灯管和标准紫外线灯管。
4.采用*特的滤色片保证高的紫外线强度及**命。
5.高强度铝合金氧化外壳。
6.可选择单灯管或双灯管模式。
8.多种供电方式选择：220V交流供电，12V蓄电池供电，2号电池供电